Go Down

Topic: Programming a mini using an UNO (Read 352 times) previous topic - next topic

sencorp

Apr 13, 2013, 10:14 am Last Edit: Apr 13, 2013, 10:50 am by sencorp Reason: 1
Hi everyone. I am trying to program my Mini Pro by using my UNO and going off the instructions from this post:

http://arduino.cc/forum/index.php/topic,7571.0.html

But I keep getting this error when I try to upload a sketch to the mini pro.


avrdude: stk500_getsync() not in sync: resp=0x00

The pro mini has a 328p and I have tried all the 328 mini selections on the IDE.
Any suggestions?


((Note:  Retracing my question. Found out that pushing the reset button first, then uploading causes it to upload the sketch no problem. Thanks for looking anyway everyone. Cheers))

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy