Go Down

Topic: Nothing shows up in Serial Monitor (Read 1 time) previous topic - next topic


Hello Firneds
HW Set up: Arduino BT board(Atmega 328); Computer has USB BT dongle;
SW set up: Arduino 1.0.3, Win vista;
Programming mode checked: AVRISP Mk2; Baud 9600;
Even for the following simple code the serial monitor does not give any out put. I try including <SoftwareSerial.h> and no luck.
Any suggestions please?

Code: [Select]
void setup() {
    Serial.begin(9600); // opens serial port, sets data rate to 9600 bps
    Serial.println("Hello Computer");

void loop() {

  Serial.println("Hello Computer");


James C4S

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com


Yes paired. Link is up when opening serial monitor. Able to download blink sketch. However no luck in making serial comm working. Thanks

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131