Pages: [1]   Go Down
Author Topic: Nothing shows up in Serial Monitor  (Read 465 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello Firneds
HW Set up: Arduino BT board(Atmega 328); Computer has USB BT dongle;
SW set up: Arduino 1.0.3, Win vista;
Programming mode checked: AVRISP Mk2; Baud 9600;
Even for the following simple code the serial monitor does not give any out put. I try including <SoftwareSerial.h> and no luck.
Any suggestions please?

Code:
void setup() {
    Serial.begin(9600); // opens serial port, sets data rate to 9600 bps
    Serial.println("Hello Computer");
}

void loop() {

  Serial.println("Hello Computer");

}
Logged

Austin, TX
Offline Offline
Faraday Member
**
Karma: 71
Posts: 6106
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Are the devices paired?
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes paired. Link is up when opening serial monitor. Able to download blink sketch. However no luck in making serial comm working. Thanks
Logged

Pages: [1]   Go Up
Jump to: