Go Down

Topic: R701 stepper driver +Arduino (Read 463 times) previous topic - next topic


Has anyone try to use this stepper driver with an Arduino?


I just read the manual and I think that it is easy to drive through simple code for steppers (with a library like Stepper.h for example).
Is that correct?

Here is the manual: (http://edge.rit.edu/content/P10503/public/R701-manual_v6_28.pdf)


Looks a pretty standard step+direction based controller...  should be OK but it doesn't actually say how much current the
inputs take - hopefully less than 40mA (probably 20mA or so - opto-isolators are usually around this level).
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131