Go Down

Topic: dagu wild 6x6 (Read 742 times) previous topic - next topic


I try to tune my dagu.  I could use it with RC.  I put 2 RF04 on the front to be sure to stop it next to wall.
I try to use a flag it come HIGH when RF04 = 5cm.  But in the code when I try to use this flag the dagu never move.
Any idea?



You need to post your code.


I solved this problem.
Bug you know 1 soleved and an other one appear ;-)

I made a communication between dagu arduino control board and a arduino mega.  The communication work but when I unplug usb cable form my mega bord and use a external power supply lipo 11v.  The communication stop.  Did you if when I use an external power the localisation i2c pin change or maybe there is something to code.



solved again :-)

I have to use the same GND.  Forgot the base.


Go Up

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

shortcuts: alt+s submit/post or alt+p preview