Pages: [1]   Go Down
Author Topic: DMX on Arduino DUE (DMXSimple/DMXSerial)  (Read 1702 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, does anyone know if the DUE works with any DMX library and Shield?

They seem to work with AVR libs that are not available (in 1.5.1)..

Thanks!
Klaas
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have the same problem / question. Any help would be great!
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have the same question. Any news?
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 17
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

+1 bump
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I have exactly the same question.

I talk especially to the Arduino team, it's good to get out an Arduino DUE powerful, but if you don't create compatible libraries...

I bought an Arduino DUE and I can make anything.

I understand that you don't have time to recreate all existing libraries, but in this case you could make a tutorial that explains how to create a library.

Apart from that, you do a great job and I love Arduino, thank you !
Logged

Offline Offline
Full Member
***
Karma: 0
Posts: 120
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'd love to know about this too (both TX and RX) - I am thinking of buying a Due :@)
Logged

while (z--) { snore; }

Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

after one year, no answer from community?

(just new here, and same question comes to me!)
Logged

Offline Offline
Newbie
*
Karma: 2
Posts: 11
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hy Guys,

What I see in this case is that Arduino Due can only supports 3.3 v in the i/o. So, dmx works with 5v.

 I supose that It can works with the correct resistances... but it is a little dangerous.
Logged

Offline Offline
Full Member
***
Karma: 0
Posts: 120
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Mr Pacheko,

Not quite, I am sure there are several 3.3v RS485 interface chips available on the market (like the LTC1480) - you would need to have this interface chip between the Arduino pins and the DMX outside world. DMX works on a differential bus system and not 0-5v as you stated.

I have been using SN75176, which I believe will work at 3.3v but I havent tested it

Regards
Logged

while (z--) { snore; }

Pages: [1]   Go Up
Jump to: