Go Down

Topic: Hello there,some help needed (Read 3293 times) previous topic - next topic


Feb 04, 2013, 04:12 pm Last Edit: Feb 04, 2013, 04:19 pm by dimitris127 Reason: 1
Hi there guys
I'm doing a project where I have a lilypad xbee and an arduino duemilenova and i would like to connect them through xbees.I tried successfully to program the xbees through xctu to connect with each other.Thing is until now i was using a normal lilypad not a lilypad xbee and i have no idea how to program the lilypad xbee,is it possible to get a 6 male header and solder it to program it like any other lilypad or are the pins used for some other reason?

ED:hi again,it seems i had a misunderstanding,lilypad xbee is must be connected to the lilypad mainboard xD

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131