Pages: [1]   Go Down
Author Topic: Arduino UNO: D11, D12 and D13 after reset pulse  (Read 484 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi

I notice there is a 3 pulses/spikes on the UNO D11 (MOSI), D12 (MISO) and D13 (SCK) each time i press the reset button.
This is not observed in other IOs.
All above IOs are set as output.

D11 - 1.5V spike, 124ms between each
D12 - 3V spike, 124ms between each
D13 - 5V pulses, ~8Hz, 124ms pulse width (50% duty cycle).

Anyway to prevent this?
I used these pins at OUTPUT to trigger another circuits.
This caused false trigger when power up or reset.
Logged

Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 437
Posts: 23660
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

You could try 1K to 5K to 10K pullup or pulldown resistors so the pins are not floating immediately after the reset.
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Pages: [1]   Go Up
Jump to: