IF time = 10:AMTHAN LED 1 = high;ELSEIF time = 11AMTHAN LED 2 = high;ELSEIF time = 12: PMTHAN LED 3 = high; etc...Thereafter,IF pushbutton 1 (which is attached to LED 1 -- the 10AM LED) is pressedTHAN println"the 10AM pusbutton was pressed at 10:12";IF pushbutton 2 (which is attached to LED 2 -- the 11AM LED) is pressedTHAN println"the 11AM pushbutton was pressed at 11:24";etc...
if time.now == 8:00 than close switch to LED 1 etc..
if button pushed than send time to serial monitor
I have reworked on the circuit in where I have three time switches and three pushbutton switches.
How would you recommend making the circuit?
I would wire up the push buttons between an input and ground, and enable the internal pull up resistors in software.
I don't know what you want to do with the time switches but one way would be to wire them up just like push buttons and wire the LEDs to three outputs.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16