Pages: [1]   Go Down
Author Topic: Hello there,some help needed  (Read 2439 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi there guys
I'm doing a project where I have a lilypad xbee and an arduino duemilenova and i would like to connect them through xbees.I tried successfully to program the xbees through xctu to connect with each other.Thing is until now i was using a normal lilypad not a lilypad xbee and i have no idea how to program the lilypad xbee,is it possible to get a 6 male header and solder it to program it like any other lilypad or are the pins used for some other reason?

ED:hi again,it seems i had a misunderstanding,lilypad xbee is must be connected to the lilypad mainboard xD
« Last Edit: February 04, 2013, 10:19:13 am by dimitris127 » Logged

Pages: [1]   Go Up
Jump to: