Pages: [1]   Go Down
Author Topic: Uart port in SPI mode on Arduino Mega 1280  (Read 330 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 46
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I was able to operate the Uart port in SPI mode on the Arduino 328. However, when I try to run on the Arduino Mega 1280, I am unable to get it working. I believe the issue is because xck0 line is not routed to pin 4(or any pin for that matter). In fact, none of the xck# lines are routed to pins. It seems odd that none are routed to pins. Is there a way to access the functionality of these pins from another accessible pin? Could an interrupt be used?

Thanks,

-diesel
Logged

Pages: [1]   Go Up
Jump to: