Pages: [1]   Go Down
Author Topic: Arduino UNO R3 cannot be detected by Windows XP  (Read 523 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello All,

I am new to Arduino. Recently I have bought an Arduino R3 and install all the drivers and IDE as usual. It works fine for a few days and suddently it cannot be detected in Windows XP. It shown "Unknown Device" under the USB interface. I cannot reinstall the drivers, it always said "unknown device" is the best driver u can install.

I try to upload the bootloader via another arduino uno R3. The upload is success, but when I connect the board to the PC again, it cannot be detected either. I try the DFU mode to update the firmware, but I cannot enter the DFU mode even I have short the two pins required.

If I cannot detect the arduino board by PC, what can I do to fix it? Thanks for all your kind advice.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

more info:
When i am connecting the arduino, the LED on pin13 will blink in 3 times an interval.
Logged

Chile
Offline Offline
Edison Member
*
Karma: 32
Posts: 1233
Arduino rocks?
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Manual (official) option: http://arduino.cc/en/Guide/Windows

Automatic option: http://arduino.cc/forum/index.php/topic,118440.0.html
Logged

My website: http://ried.cl

Pages: [1]   Go Up
Jump to: