Go Down

Topic: Arduino UNO R3 cannot be detected by Windows XP (Read 699 times) previous topic - next topic

Hello All,

I am new to Arduino. Recently I have bought an Arduino R3 and install all the drivers and IDE as usual. It works fine for a few days and suddently it cannot be detected in Windows XP. It shown "Unknown Device" under the USB interface. I cannot reinstall the drivers, it always said "unknown device" is the best driver u can install.

I try to upload the bootloader via another arduino uno R3. The upload is success, but when I connect the board to the PC again, it cannot be detected either. I try the DFU mode to update the firmware, but I cannot enter the DFU mode even I have short the two pins required.

If I cannot detect the arduino board by PC, what can I do to fix it? Thanks for all your kind advice.

more info:
When i am connecting the arduino, the LED on pin13 will blink in 3 times an interval.

eried

Manual (official) option: http://arduino.cc/en/Guide/Windows

Automatic option: http://arduino.cc/forum/index.php/topic,118440.0.html
My website: http://ried.cl

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy