Go Down

Topic: running dynamixel AX-18A on Arduino Mega 2560 (Read 388 times) previous topic - next topic

Hello,

I'm doing the project to control the servo motor by using MATLAB 2012a and arduino as the controller board. so far to establish and communicate between MATLAB 2012a to arduino board already success and next stage is to run the servo but always fail. what i'm wrong and what i have to do? this is my guideline to run the motor
http://www.mathworks.com/matlabcentral/fileexchange/35641-simulink-support-package-for-arduino-mega-2560-hardware-r2012a/content/arduinomega2560/arduinomega2560demos/html/publish_arduinomega2560_servocontrol.html

any ideas in order to run the servo i really appreciative .

thanks,
faiz

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy