Go Down

Topic: Spurious input signals on switch (Read 1 time) previous topic - next topic



Got my first Due yesterday - I have tried both the internal resistor and pull up / pull down external 10k resistor.  I get an occasional read when the switch is open (but both internal and one of the 10k methods are quite bad - the other 10k method seemed to be working a lot better but also not 100%).

On a Uno it is rock solid with the same cable.

Any ideas?

I have 3.3v going to 10k, 10k going to pin 12 and gnd.



Seems to have been noise - perhaps the cable was lying too close to the stepper driver. It works fine with the internal resistor if tried standalone

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131