Go Down

Topic: ATTiny 4313 invalid device signature (Read 813 times) previous topic - next topic

rufi

I'm trying to load the Basic blink program to the ATtiny4313 and keep getting invalid device signature?

I have followed instruction to:

load the Arduino isp 

modify the avrdude.conf file

load the ATtiny core files so I can select the 4313 as a board.

I followed the pin out on this http://www.ernstc.dk/arduino/2313.htm added the 10uf to disable the reset.

And now i'm just trying to put the Basic blink program/sketch on to the 4313?

Any ideas what might be the problem.. I'm not sure what I'm doing wrong

Coding Badly


Wiring is the most likely culprit.

A mistake...
Quote
modify the avrdude.conf file

...is the next most likely.

Post verbose output from avrdude.

rufi

It was the wiring. I guess I had it backwards.

I followed this :

http://www.youtube.com/watch?v=_ZL-YNOH_jA

now i need to figure out why my 5x7 led isnt displaying the images properly...

...

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy