Are defiantly wrong ive just gone through all my 20amp and 30amp chips and measured this resistanceresults as follows, these were measured on the pins nothing attached to them on ip+ (pins 1 and 2) and ip- (pins 3 and 4).acs 712 20a total 6 ics, all 0.3 ohms acs 712 30a total 13 ics all 0.3 ohmsmaby the figure they quote in their chart has a typo (m?) sould be just (?) they do mention that the data was made using theAllegro ASEK712 demo board maby this resistance comes from extra circuitry there maby? but looking at it cant see any components that would suggest thisbe really great if someone else could also confirm this resistance as well
Hey guys, sorry for digging up this old post. I am making the PCB right now and I am wondering what is the purpose of the 0.1uF cap.Let say I am going to include 10 ACS714 on a single board. According to the data sheet, a 0.1uF cap is suppose to be connected from VCC to GND. Can I just use one cap for all the ACS714? Should it be 0.1uF or 1uF? Thank you so much!