Go Down

Topic: 12 Servo Quadruped - Servo Shield selection discussion (Read 12532 times) previous topic - next topic


If you can get hold of a prototyping shield, you can solder up a bunch of 3-row
headers yourself. Will only take about half an hour. I have used a couple of these
shields on projects, sold locally at Radio Shack, but Seeed Studio is a chinese
company, I believe,

BTW, I am testing one of my boards, and FYI, I have a 33K series-R in one of the
I/O lines going to a servo [normally used as part of a voltage divider on Vin], and
the servo moves just fine. In general, though, I would use much lower values,
largely for noise considerations, eg, 220-330 ohms.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131