Go Down

Topic: a blink sketch to a attiny-- problem (Read 399 times) previous topic - next topic

knuckles

i have mounted a attiny45 in my sparkfun avr isp shield which i successfully use with a UNO below as an ISP to load a bootloader onto other 328s with no problems .
so i now try to load a sketch onto the attiny45 ,just a simple blink sketch ,modfying the pin 13 to pin 0 for the blink sketch .but i keep getting the error message 'OUTPUT' was not declared in this scope .
why cant i get this to compile ?
the attiny is a 8 pin device .

AWOL

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

knuckles


AWOL

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

Erni

From the few details, i guess yor Tiny-core isn't installed right

Try this core

http://code.google.com/p/arduino-tiny/

Follow theese instructions

http://code.google.com/p/arduino-tiny/source/browse/trunk/readme.txt

A short guide

http://www.ernstc.dk/arduino/attiny85.html


knuckles

yea doing a general search on G shows other sufferers , due i estimate to libs not installed right although i am sure i  d/l the libs in the right places ...

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy