I really appreciate all your help!After I saw your suggestions, I started to google the components and while I was searching, I found a driver for Arduino.By writing this, I don't want you to think I'm against the suggestions you gave me. However, I'm not an expert in electronics.Don't you think I will have more chances of succeeding if I use this driver that is already assembled?Specifications:-Operating voltage: 15 ~ 24V-Rated / Peak Current: 40A/80A-Hardware architecture: high-power N-channel MOS transistor, a single full-bridge-Input PWM signal: Duty Cycle 0 ~ 98% (not more than 98%), the standard 16KHz highest 100KHz.-Supply voltage signal output: 0 ~ 5V corresponding to 0 ~ 26V-Supply current signal output: 0 ~ 5V corresponding to 0 ~ 91A
Thanks for the tip dc42. Can you explain why I would have to disconnect the motor driver every time I want to charge the battery? Or tell me where/what I have to search to find the explanation for that?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16