Go Down

Topic: Arduino Software Help Needed (Read 692 times) previous topic - next topic

armondjune

Thanks for the help. If anyone is very familiar with programming, would this job be reasonable to accomplish in a less than a week for a moderate to experienced programmer? Would this be a relatively simple job for someone familiar with programming?

MichaelMeissner

#6
Feb 07, 2013, 08:46 pm Last Edit: Feb 07, 2013, 10:45 pm by MichaelMeissner Reason: 1

Thanks for the help. If anyone is very familiar with programming, would this job be reasonable to accomplish in a less than a week for a moderate to experienced programmer? Would this be a relatively simple job for someone familiar with programming?

If you don't post the program, we would just be guessing.  It may be simple, it may not be.  You need to use the '#' button above the text area to generate code tags, and put the program inside of the tags.

MAS3

Quote from: armondjune

If I have a program written in objective c (written on a mac), how would I use that program to use my robot arm using an arduino mega?


Did you write that program yourself ?
If you did, you know it and how it was built.
If you just "happened to stumble upon" it, you will probably have to guess a lot.

This will have a big impact to the time you would need to convert it.
But how do you know this program will work and do what you want it to do ?
You will see you'll need to do some debugging before your setup will do what you expect it to do.
Have a look at "blink without delay".
Did you connect the grounds ?
Je kunt hier ook in het Nederlands terecht: http://arduino.cc/forum/index.php/board,77.0.html

JimboZA

Quote
If you just "happened to stumble upon" it


8)

Is that "stumble" as in "Googled for a ready-made answer to a college project"?....
Roy from ITCrowd: Have you tried turning it off an on again?
I'm on LinkedIn: http://www.linkedin.com/in/jimbrownza

Go Up