Go Down

Topic: Uart port in SPI mode on Arduino Mega 1280 (Read 471 times) previous topic - next topic

diesel

Hello,

I was able to operate the Uart port in SPI mode on the Arduino 328. However, when I try to run on the Arduino Mega 1280, I am unable to get it working. I believe the issue is because xck0 line is not routed to pin 4(or any pin for that matter). In fact, none of the xck# lines are routed to pins. It seems odd that none are routed to pins. Is there a way to access the functionality of these pins from another accessible pin? Could an interrupt be used?

Thanks,

-diesel

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy