Go Down

Topic: CuteDigi RS232 Shield, need docs or help (Read 414 times) previous topic - next topic

plbyrd

I need to wire up the hardware flow control lines of the CuteDigi RS232 shield to lines on my Mega 2560.  Looking at the shield board, it does not appear that any lines other than Tx and Rx are hooked up to the MAX232 and DB9.  Am I seeing that correctly?  Am I just better off prototyping a custom MAX232 board, or is there an RS232 shield available with all the control lines wired up?

CrossRoads

Male & female connecter versions with RTS/CTS pins are available here.
http://www.nkcelectronics.com/rs232-to-ttl-converter-board-33v232335.html
http://www.nkcelectronics.com/RS232-to-TTL-converter-board-DTE-with-Male-DB9-33V-to-5V_p_369.html
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy