Go Down

Topic: Do i need a separate power supply for multiple HCSR04 ultrasonic modules? (Read 1 time) previous topic - next topic


two work fine on my current robot.  I am to up the ante by using my arduino on a larger system which may require as much as 8 on my offroading one. I will also have 2 temperature sensors to monitor my mootor driver temp and switch the fan on when needed.

I am thinking of putting a 5v regulator with a common ground to power up my sensors. any thoughts? i have a 5v 1amp regulator gathering dust.


The only current specification I can find for the HC-SR04 is "quiescent current : <2mA".

I'm guessing that the active current draw is low enough that running 8 of them off the Arduino power rail would not be a problem.
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131