Go Down

Topic: Arduino Promini program burning problem (Read 2985 times) previous topic - next topic

dattasaurabh82

I recently got an Arduino Pro Mini 3.3V/8MHz & also I was having a FTDI Break out board
(This one):

Now The Rx-TX lines are of 5volts here unlike the Sparkfun's FTDI board which is having a jumper two logically lower the communication pins.
My Board on the other hand have only a 3.3v VCC line along with a separate 5v VCC, but no jumper to logically lower the communication pins.

I did a mistake:
I connected the 3.3v of the FTDI board to the Arduino Pro mini's VCC.
Rx(5volt logic) of FTDI board - Tx of Arduino Pro mini.
Tx(5volt logic) of FTDI board - Rx of Arduino Pro mini.
Gnd - GND.

And now all my pins of arduino Pro mini shows 3.3v high logic when I disconnected the FTDI board & connected a 3.3v poer supply to the Arduino.

Is it fried? I ordered the Sparkfun's 3.3v FTDI board recently.

NI$HANT

#1
Feb 17, 2013, 07:42 pm Last Edit: Feb 17, 2013, 07:49 pm by NI$HANT Reason: 1
The pins there handled +5v whereas the uC was operating @ +3.3v
"Real Men can Accomplish  Anything"

- skype : nishants5  

ਫ਼ਤੇਹ ਕਰੁਂ!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy