Pages: [1]   Go Down
Author Topic: using atx power supply with motors  (Read 293 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 6
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I want to use a ATX power supply (from a computer) to supply power to 3 motors 12 volt and 3 volt,  how do i connect the different electric wires (which ground etc.)?

Does anybody have a sketch or drawing about this?

Manchester (England England)
Online Online
Brattain Member
Karma: 634
Posts: 34547
Solder is electric glue
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Keep all the grounds common to the supply and arduino.

Then decide how you want to power the motors, see:-

Keep the + of the 12V to power the higher voltage motors and the 3V for the lower powered ones. You can even use the 5V to power the Arduino. However be aware that the power supply can give out a lot of current so it is rather unforgiving about shorts.
« Last Edit: November 09, 2009, 04:41:42 pm by Grumpy_Mike » Logged

Pages: [1]   Go Up
Jump to: