Pages: [1]   Go Down
Author Topic: DHT11 displaying incorrect values  (Read 480 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm having some issues with a DHT11 sensor. I used the tutorial in the playground section of this website, but when I run the sketch the serial monitor returns I2ýþYš’rw¢’dB‹òþd°šTv6 ect. What am I doing wrong? Is the sensor just bad?


Thanks!

Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 201
Posts: 8685
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Looks like a baud rate problem.  Is the baud rate at the bottom of Serial Monitor set the same as the baud rate passed to Serial.begin() in your sketch?
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

That was it! Thank you!
Logged

Pages: [1]   Go Up
Jump to: