Go Down

Topic: cruise control on motorcycle, need to read timing between wheel RPMs on reed swi (Read 10654 times) previous topic - next topic

PaulS

Quote
Yeah, but are you really expecting to use cruise control at the slow speeds where that would be an issue?

On my bike, cruise control will not engage at less than 30 mph or over 88 mph. There are very good reasons for this.
The art of getting good answers lies in asking good questions.

wildbill

Any idea why 88mph is the limit? Is it a back to the future thing?

PaulS

Quote
Any idea why 88mph is the limit?

88 mph == 140 kph. I presume that the programmers were not Americans.
The art of getting good answers lies in asking good questions.

GoForSmoke

Lag is lag. Reducing lag gives better response, better control, it's as simple as that.
How many times a second does the wheel turn at 60 mph? I get about 12.6 times on guess. Go run a sim at 13 fps and see where there might be problems.
1) http://gammon.com.au/blink  <-- tasking Arduino 1-2-3
2) http://gammon.com.au/serial <-- techniques howto
3) http://gammon.com.au/interrupts
Your sketch can sense ongoing process events in time.
Your sketch can make events to control it over time.

KingKev69

Great project. want to do similar.
Don't get onto forums offtend, because of the negative know all unproductive people, whom dont have much substance just a mouth, or this case keyboard.
been riding bikes for 45 years and not one of them did'nt have enough rear brake power to stall the engine....

I though of using a digital push bike speedo to give front wheel speed

Go Up