Pages: 1 [2]   Go Down
Author Topic: The ants come marching in (and release magic smoke)  (Read 1496 times)
0 Members and 1 Guest are viewing this topic.
Denmark
Offline Offline
God Member
*****
Karma: 15
Posts: 727
Please don't send questions as PM!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The places the ants were stuck has nothing to do with the problem at all. That solder joint got cold over time (thermal expansion and contracting) over time which leads to a failed solder joint like that. Also if the component soldered in that joint has some mass, the vibration from you opening and closing of the door makes it shake loose over time, rendering you with the same problem.

This time it was not the fault of the bugs...

// Per.
Logged

0
Online Online
Shannon Member
****
Karma: 206
Posts: 12168
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

It may also have touched the metal casing?  Looks like a high-current discharge caused the blackening.  The leads on that
board have not been cropped short, i.e. poor build quality.   Ants are usually associated with high voltage flashover in the mains
section of an appliance - they are one reason why mains wiring should never run close to sensitive low-voltage circuitry!
Logged

[ I won't respond to messages, use the forum please ]

London
Offline Offline
Edison Member
*
Karma: 47
Posts: 1432
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

It's the superconducting ant spit that does it...


ANTimatter...
Logged

Offline Offline
Full Member
***
Karma: 2
Posts: 138
W9LZ
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Of course they're electromagnetic....ANTennas.
Logged

Pages: 1 [2]   Go Up
Jump to: