Looks like I found the problem. I am using the ads1115 chip (not breakout board!) . I glued it to a blank breadboard and soldered it to the arduino. My soldering skills are excellent but the tiny legs of the chip could not stand the pressure of the magnet wire. Even though I thought I had plenty of stress relief by gluing the wire down right next to the chip, it must of been to much and the sdl leg broke and rested on the vdd line. I bought a new micro and everything is fine. I am also buying a breakout board with the ads1115 already on it.
My question is can the board be revived? Is there a specific chip that may have been fried that I can replace? Thanks, Victor.