Go Down

Topic: Do 2 XBee Serie1 need configuration router/coordinator ? (Read 386 times) previous topic - next topic

julienbayle

Feb 12, 2013, 07:01 pm Last Edit: Feb 12, 2013, 07:04 pm by julienbayle Reason: 1
Hi there,
targeting XBee 1mW Serie 1 for my project (one will be a remote device, the other one connected to the computer via XBee Explorer board, I'd like to know if with Serie 1 I need to configure one as a coordinator and the other a router or not ?!

I'm confused about this.

Any leads or advices would be very appreciated :)
Julien
http://julienbayle.net

PaulS

Quote
I'm confused about this.

I don't see how or why. The options to configure point to point models as router, coordinators, or end devices do not even exist.

julienbayle

Serie2 are the other model for which this exists ?
If the answer is yes, that will definitively unconfuse me  8)
Julien
http://julienbayle.net

PaulS

Quote
Serie2 are the other model for which this exists ?
If the answer is yes, that will definitively unconfuse me

Yes. Only mesh network models can be configured as nodes in a mesh network.

julienbayle

This page confused me
www.digi.com/support/kbase/kbaseresultdetl?id=2213

But indeed mesh required something particular for series1... And I don't need that, so

Thanks  to have un confused me!
Julien
http://julienbayle.net

Go Up