Pages: [1]   Go Down
Author Topic: Hardware vs. Software debounce  (Read 600 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
God Member
*****
Karma: 19
Posts: 785
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I've been finding lately that with most little projects it is easier for me to just stick a cap across my buttons than it is to put in debouncing code. 

Is there any advantage or disadvantage to doing so that I might not be seeing?  Is there a cap value that is preferred for this?  Seems like I have used everything from 1 to 100nF and been just fine. 
Logged

Offline Offline
Faraday Member
**
Karma: 68
Posts: 2787
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

https://www.youtube.com/watch?v=CRJUdf5TTQQ&list=ECA567CE235D39FA84&index=10
Discusses Hardware debouncing.
Logged

The way you have it in your schematic isn't the same as how you have it wired up! That goes for me too.

Pages: [1]   Go Up
Jump to: