Hi PaulS, i've got to the task where i control the servo with arduino software.The problem was, where i upload the code on arduino the baudrate was set to:
HerkuleX.begin(57600, RX, TX);
where the default baudrate for HerkuleX servos is 115200 so i change code to:
HerkuleX.begin(115200, RX, TX);
Then in Arduino software, in monitor mode i was able to move the position of the servo as is shown in pdf file, Point4 (2)Test .
But im still having problem with HerkuleX Manager software when i change the setting to the right COM the same as arduino board is connected to and change the baudrate to 115200 and i click "Connect" still HerklueX Manager can't find the HerkuleX Servo model. So i could change the baudrate communication to 57600.
Any clues. Thanks Lukas