Go Down

Topic: Listening to 12V Signals with Optocouplers? (Read 2013 times) previous topic - next topic

pwillard

I was referring to COMMON VENDOR pricing for roughly a worst case scenario (besides Radio Shack)... but my point is  resistors are  only pennies.  Personally, I buy my resistors from places like Tayda at $0.03 each

sgtpepperaut


well i certainly didn't mind the cents that the resistor cost more the soldering of the board. anyways i agree with whats being said here i just wanted to understand the fundamentals behind it.

thx for all the input.

anyways circuit is done and its right on the sweetspot:
10mA a Pop for a total of 60mA draw at 12V...woho :)


still have to get some experience soldering but it worked out okay..



sgtpepperaut

and the updated schematic for people to reference:

Nick Gammon

I got these zero-ohm resistors for $4 for a batch of 500:

Please post technical questions on the forum, not by personal message. Thanks!

More info:
http://www.gammon.com.au/electronics

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy