1) I want to use the Arduino and a 2N2222 transistor to switch a camera on/off switch. The camera will be ran off the 5v arduino pin - no info on how many mA it uses but it has a 220mA battery...What resistor will i need for this transistor?
2) I am also going to run a 350mA 1W LED off the 5v arduino pin and want to switch it on/off hopefully with a TIP120 transistor from the arduino. What resistor will i need for this transistor?
Also, i read that the 5v can supply up to 1A so 350ma LED should be fine right - will it draw the right amount of current it needs to run/ i dont really know anything about led drivers. ... I worked out i would need a 10ohm for the LED
On top of this, i have read on the net that some people don't use resistors with transistors and it worked fine - whats going on!
Thanks fungus! Cleared up a few things.I ran a formula and worked out i should use a 2.5k ohm resistor for the TIP120 running a 1W LED. Does this sound in the ballpark?
Bit wary of running a led straight off the power supply - so i saw some cheap 1w led drivers on ebay. They run on 12v. Do you think i could switch one of these with another resistor and an external power supply?
It doesn't have an operating voltage, i was just going to run it at 5v originally from the arduino 5v pin?
This is my LED: http://www.ebay.com.au/itm/1W-Infrared-IR-940NM-High-Power-LED-Bead-Emitter-with-20mm-Star-Base-/221063642644?pt=LH_DefaultDomain_0&hash=item33786b7e14&_uhb=1#ht_4040wt_1163
I used this calculator to calculate resistor values for transistors:http://kaizerpowerelectronics.dk/calculators/transistor-base-resistor-calculator/I thought forward voltage was not operating voltage - just the volts that drops once it's through the LED? I could run a 184.108.40.206v drop led on 5v no?
On another note I could use 50x 5mm LEDs like these:Forward Voltage (V) : 1.2-1.4V.Forward Current (mA): 100mA.
Once again they have 1.2-1.4 forward voltage - could I run them from 5v? If so would the Arduino have enough milliamps to run 50 of them in series and what resistor should I have? Looks to me like they would use 5A.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16