Go Down

Topic: 1-wire sensor network with multiple DS18B20 .... need som input/help (Read 1 time) previous topic - next topic

Sebastian_DK

Hi

I'm planning on making an multi channel temperature monitor based on an Arduino, perhaps a pro mini, and a 1-wire bus with DS18B20 temperatur sensors.

I contemplates using 3.5mm stereo jack plugs as external connections, one for each "channel" (sensor), is there a way to make the Arduino determin which sensor adress is connected to which "channel" (jack socket) so that I don't have to manually set up the system to know what each measurement represents.

Best regards
Sebastian
---------------
Just finding my place in the wonderfull world of Arduino

afremont

Each sensor has a unique ID that can be read from the device.  You could read this number and integrate it into the system each time you acquire/assign a new sensor.  Internally, all the sensors could be on the same electrical 1-wire bus so it didn't matter which connector a sensor got plugged into.  You then specifically address the sensor that you want to read at run-time.
Experience, it's what you get when you were expecting something else.

Nick_Pyner

#2
Feb 15, 2013, 03:13 pm Last Edit: Feb 15, 2013, 11:54 pm by Nick_Pyner Reason: 1
This code finds the address. As you can see, it came from Hacktronics.

Using stereo jacks is as good as anything else. I use the cheapo flat plugs a lot of DS18B20s already come with.

Code: [Select]
// This sketch looks for 1-wire devices and
// prints their addresses (serial number) to
// the UART, in a format that is useful in Arduino sketches
// Tutorial:
// http://www.hacktronics.com/Tutorials/arduino-1-wire-address-finder.html

#include <OneWire.h>

OneWire  ds(3);  // Connect your 1-wire device to pin 3

void setup(void) {
 Serial.begin(9600);
 discoverOneWireDevices();
}

void discoverOneWireDevices(void) {
 byte i;
 byte present = 0;
 byte data[12];
 byte addr[8];
 
 Serial.print("Looking for 1-Wire devices...\n\r");
 while(ds.search(addr)) {
   Serial.print("\n\rFound \'1-Wire\' device with address:\n\r");
   for( i = 0; i < 8; i++) {
     Serial.print("0x");
     if (addr[i] < 16) {
       Serial.print('0');
     }
     Serial.print(addr[i], HEX);
     if (i < 7) {
       Serial.print(", ");
     }
   }
   if ( OneWire::crc8( addr, 7) != addr[7]) {
       Serial.print("CRC is not valid!\n");
       return;
   }
 }
 Serial.print("\n\r\n\rThat's it.\r\n");
 ds.reset_search();
 return;
}

void loop(void) {
 // nothing to see here
}


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy