Pages: [1]   Go Down
Author Topic: Programming a Fio with any other board  (Read 461 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 77
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, I would like to know if it is possible to program an Arduino Fio with a Uno, or a Due, instead of using an FTDI to usb cable.
Thanks.
Logged

L.C.

Global Moderator
Offline Offline
Brattain Member
*****
Karma: 452
Posts: 18694
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

If you connect up the appropriate 6 pins you should be able to program using ICSP devices.

Example, USBtinyISP device, Arduino as ISP, and using the sketch described below:

http://www.gammon.com.au/forum/?id=11638

In the case on my page I copy sketches to a SD card, and program using that.
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 77
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks a lot, that's all I needed to know. smiley
Logged

L.C.

Pages: [1]   Go Up
Jump to: