Go Down

Topic: A question about the two USB jacks. (Read 1 time) previous topic - next topic


I recently received my DUE :D and I have a couple micro USB cables on their way. I was just looking over the board and noticed that the USB slots are shaped just slightly different. The native port is rectangular and the programming port id "D" shaped. Will I need two different USB plugs?

Thanks for any replies,


The Native USB port on the Due uses a Micro-AB connector.  It was designed to work with both a standard USB Micro-B cable and a USB Micro-A cable.  The Native USB port can act as a USB host port.  To operate in Host mode, you will need to use a special USB Female-A to Micro-A OTG (On The Go) cable.  But for normal serial communications and programming all you need is the standard USB Micro-B cable for either USB port.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131