Pages: 1 [2]   Go Down
Author Topic: Relay switching ON/OFF rapidly by the arduino digital signal ..how to controll?  (Read 1102 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
***
Karma: 0
Posts: 109
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i powered it by arduino signal through testing code ... and it is worked well
Logged

Queens, New York
Offline Offline
Faraday Member
**
Karma: 83
Posts: 3395
"Of all the things I've ever lost, I miss my mind the most" -Ozzy Osbourne
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm sure it appears to work well, but it is not good on the arduino. It's a bad habit that many newbies overlook and wonder why their arduino stops working correctly, days or even weeks later.
Logged

Created Libraries:
NPV2 (NewPasswordV2),  TFT_Extension, OneWireKeypad, SerialServo.
Will provide libraries if asked in PM or forum.

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17259
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i powered it by arduino signal through testing code ... and it is worked well

Do you want help or just validation of what you are presently doing? Post a link to your specific relay so we can look at it's electrical requirements.

Lefty

Logged

0
Offline Offline
Tesla Member
***
Karma: 141
Posts: 9470
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Have you tried increasing the delay to 300 and printing the analog value to the serial monitor to see what the values are?
Logged

Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   smiley-cool

Pages: 1 [2]   Go Up
Jump to: