Ora volevo provare a fare a creare qualcosa di autonomo, insomma che funzioni senza essere attaccato al pc [...] qualcuno sa aiutarmi o indicarmi una guida? grazie!
PowerThe Arduino Uno can be powered via the USB connection or with an external power supply. The power source is selected automatically.External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by [i]plugging a 2.1mm [b]center-positive[/b] plug into the board's power jack[/i]. Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector.The board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 7 to 12 volts.The power pins are as follows:VIN. The input voltage to the Arduino board when it's using an external power source (as opposed to 5 volts from the USB connection or other regulated power source). You can supply voltage through this pin, or, if supplying voltage via the power jack, access it through this pin.5V.This pin outputs a regulated 5V from the regulator on the board. The board can be supplied with power either from the DC power jack (7 - 12V), the USB connector (5V), or the VIN pin of the board (7-12V). Supplying voltage via the 5V or 3.3V pins bypasses the regulator, and can damage your board. We don't advise it.3V3. A 3.3 volt supply generated by the on-board regulator. Maximum current draw is 50 mA.GND. Ground pins.IOREF. This pin on the Arduino board provides the voltage reference with which the microcontroller operates. A properly configured shield can read the IOREF pin voltage and select the appropriate power source or enable voltage translators on the outputs for working with the 5V or 3.3V.
Se hai uno standalone e vuoi caricare lo sketch tramite bootloader o togli il micro (cosa non possibile con la versione SMD) oppure ti procuri un'interfaccia USB-Seriale tipo --> http://www.robot-italy.com/it/usb-to-serial-converter.htmlLa puoi anche acquistare nello store ufficiale di Arduino (http://store.arduino.cc/ww/) o dove più ti garba.
Si lo puoi caricare ma senza bootloader caricando prima su Arduino SMD lo sketch "Arduino ISP" e poi, seguendo la guida di Menniti, sul secondo micro via ISP.In questo modo però avrai sempre l'Arduino SMD impegnato a fare da programmatore ISP.
With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.
Warning: this topic has not been posted in for at least 120 days.Unless you're sure you want to reply, please consider starting a new topic.