Pages: [1]   Go Down
Author Topic: Diptrace Files for Shield Development  (Read 1352 times)
0 Members and 1 Guest are viewing this topic.
Netherlands
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I know that a lot of people are using diptrace for designing PCB's, and this program gives verry good Gerber Output for PCB production. But after hours of "Google" did not find any good resource. So I created my own. its nice if any of you would also share there files, so we would have a place to go..
I still have to figure out to upload files here, But the board developed is for the MEGA 2560. and is the exact size of the original board, all elevated pins included with text in silk layer, and the mounting holes are also pressent. this should be a good start for developing your own shield.
next I will develop a "development board wich has enough leds, switches with and without hardware debounch, two on board potmeters, and a buzzer, the rest of the I/O points from the main board will be available the headers. this eliminate a lot of breadboard issues for a lot of development stages.. so if anyone is interested in this one also please let me know... (planning to make a basic empty shield in Diptrace for several boards)

* mega Shield 02.dip (59.86 KB - downloaded 80 times.)
Logged

0
Offline Offline
Full Member
***
Karma: 1
Posts: 185
www.rocketscream.com
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think the pad hole size is a bit small (20 mil, 0.5 mm).
Logged

Netherlands
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The pads are the original size, the same as the Arduino itself, but they can easaly be changed.
Raster = 2,54 
Logged

Pages: [1]   Go Up
Jump to: