Go Down

Topic: Problem using the Utouch library (Read 540 times) previous topic - next topic


I'm using this TFT display touch shield with a Arduino Leonardo board
with the UTFT and UTouch libraries.
The example UTouch_ButtonTest works apart from the position detected seem completely off. The buttons are not correctly detected. Therefore I have tried the UToch_Calibration example. After updating the UtouchCD.h file according to given values things seem even more wrong. I only get x,y values of 0,0 or -1,-1 no matter were I touch the screen.
The new calibration values I got was
CAL_X 03D780A2UL
CAL_S 0000000UL

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131