Go Down

Topic: Control of 6 12VDC linear actuators with Arduino Mega (Read 1 time) previous topic - next topic


I'm currently working on a project that needs independent operation of 6 linear actuators.  I was planning on using an Arduino Mega with three motor shields but after looking around I can't say for sure if its possible to have three motor shields coupled with the Mega.  I just want to make sure that it is possible before purchasing the shields.  I have seen independent operation of 4 motors using 2 shields with some pin trimming.

The project is just extending one of the actuators after sensing a corresponding input and then retracting.  So I need 6 pins available for inputs as well.

The current draw of each actuator is 2A and they are 12V.  Only one actuator will be moving at any given time and I don't need to use PWM as they will be used full speed each direction.



You should be able to operate the actuators using two 8 relay boards like below (four actuators per board)

Google forum search: Use Google Search box in upper right side of this page.
Why I like my 2005 Rio Yellow Honda S2000  https://www.youtube.com/watch?v=pWjMvrkUqX0


I'll check into that, thanks for the response.  I'm relatively new to the whole Arduino world so I'm not as familiar with all the add-ons and options that are available to do this.  The other option I considered was just building a circuit with all the necessary transistors and H-bridges but I would rather avoid that if possible.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131