Pages: 1 [2]   Go Down
Author Topic: Arduino Leonardo troubles reading from Serial1  (Read 3527 times)
0 Members and 2 Guests are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 22
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think I have some breakthrough ! Apparently FTDI module I have doesn't work properly, even It use to work with other setup before ! smiley-sad
I've connected it to Prolic USB/COM adapter and data is coming through.... I was so positive module is ok
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 22
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Nope... still messy, now I get something over serial, but what I send not what I receive over Serial1 (COM3), instead of 1 I receive g and so on....
When I switch Putty to work with Serial (COM8) it works perfect....(same settings just different COM port) WTH !? smiley-sad
Logged

Global Moderator
Melbourne, Australia
Online Online
Brattain Member
*****
Karma: 511
Posts: 19338
Lua rocks!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Let's see the current sketch.
Logged

http://www.gammon.com.au/electronics

Please post technical questions on the forum - not to me by personal message. Thanks a lot.

Offline Offline
Newbie
*
Karma: 0
Posts: 22
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Finally!!! I got it, apparently Prolific modules doesn't work properly with Leonardo, the very first one on the picture is Prolific as well, not FTDI.
So luckily I had one actual FTDI attached to my MultiWii controller, when I've used that one - now all works!

They actually partially working , writing data from Arduino to PC was fine! But not reading! Crazy... I have no idea why it was so messy with Prolific chip based Ser/USB breakout boards, any ideas?
« Last Edit: February 25, 2013, 10:29:32 pm by ectar » Logged

Pages: 1 [2]   Go Up
Jump to: