Go Down

Topic: Reflux distiller (Read 443 times) previous topic - next topic

nativepr

Hi, i am working with a project for a reflux distiller i am using a pid but i want to change to a arduino . I see in the forums some projects and
codes for a brew systems but i need to control the water flow in a reflux tower. I have the experience with the electronic but not in the programing of the arduino. For your reference in the still we need 3 sensors, for mash temp,reflux tower temp and and liquid flow ( for the final alcohol ) log this readings ( mash temp,reflux temp, alcohol flow and time procedure ) and 3 out puts, for the mash we can use a relay for on/off the 220v resistance or a servo for a open/close slow a gas valve. For the reflux tower the we can use a relay for turn on/off a electric valve or use  a servo for turn open/close slow a water vale. The liquid flow its a monitor log only. The mash temp and reflux tower need a set point. Any help appreciated. Thanks a lot for your answer.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy