I've managed to design my very first pcb. It's a sensor board, with room for an atmega328 and 3 analog inputs, as well as a status LED and a 2x4 pin-header where is meant to go a nordic transceiver breakout module.
Very interesting. The first dedicated board I have seen and, if I can be sure of the Nordics delivering the goods, I am looking at doing pretty much the same thing. I submit the diagram below as i9ntellectual exercise...I would be interested to see how you finish up with this.
Are ground pins 8 and 22 connected? They should be.
That smiley should be pin EIGHT - how do I stop it doing that?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16