Pages: 1 [2]   Go Down
Author Topic: I2C help needed  (Read 1475 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
***
Karma: 2
Posts: 109
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks Nick.
As usual you are such an asset to this forum.
So it seems my output must be correct then. It sure seems correct as I rotate the magnet.
Does your I2C Scanner find your device?
Logged

Global Moderator
Melbourne, Australia
Online Online
Brattain Member
*****
Karma: 511
Posts: 19362
Lua rocks!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks Nick.
As usual you are such an asset to this forum.
So it seems my output must be correct then. It sure seems correct as I rotate the magnet.
Does your I2C Scanner find your device?

Thanks! smiley

No, in my case it was configurecd as an SPI device (and soldered onto a board that I can't change). I'm a little surprised that the scanner doesn't find it, however if the figures are correct presumably it is there.
Logged

http://www.gammon.com.au/electronics

Please post technical questions on the forum - not to me by personal message. Thanks a lot.

Pages: 1 [2]   Go Up
Jump to: