Pages: [1]   Go Down
Author Topic: problem while burning bootloader  (Read 384 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,
I am trying to burn bootloader on atmega328 using arduino uno.
I have used method shown on:http://arduino.cc/en/Tutorial/ArduinoToBreadboard

But getting error as :avrdude: stk500_getsync(): not in sync: resp=0x00
Logged

Denmark
Offline Offline
Full Member
***
Karma: 10
Posts: 224
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

is it on the right port?
That has been my problem when I got that message.

There are some other possibilities here:
http://www.ladyada.net/learn/arduino/help.html
Logged

Bob Pease: "My favorite programming language is ... solder."

USA
Offline Offline
Jr. Member
**
Karma: 0
Posts: 68
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Try this guide to see what's going on with the chip (I connected pin 9 from the Arduino to pin 9 on the breadboarded chip as opposed to using a crystal):

http://www.gammon.com.au/forum/?id=11633
« Last Edit: March 03, 2013, 10:54:26 am by Nicknml » Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have checked my connection and port.Both are correct ut still getting same error.
Logged

Pages: [1]   Go Up
Jump to: