Pages: [1]   Go Down
Author Topic: Interrupt Program  (Read 206 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
Karma: 0
Posts: 72
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, i want to make 3 axis gimbal using arduino. I use 3 servo motor and multiwii board to control the stabilization. So far i success to stabilized all of three axis. But, i want to make additional feature to this system, the manual control. So, when the stabilized system active, i can interrupt the program with the manual control of servo too, and the system can detect the last position of manual control of servo, then stabilized the last position.

How can i do that?

Thank you..

Global Moderator
Offline Offline
Brattain Member
Karma: 310
Posts: 26632
I don't think you connected the grounds, Dave.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You could start by posting your code.
An interrupt doesn't sound like it will be a useful option.

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

Pages: [1]   Go Up
Jump to: