Pages: [1]   Go Down
Author Topic: EasyVR+ adafruit motor shield  (Read 368 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 14
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey guyz!,
I am using EasyVR and adafruit motor shield for my voice controlled wheelchair. Whenever i connect both the shields to UNO and a PC I get an error message EasyVR not detected. Please help!..
http://www.adafruit.com/products/81
https://www.sparkfun.com/products/10963
Logged

Offline Offline
Edison Member
*
Karma: 58
Posts: 2078
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

They probably share some pins.

The Adafruit Motor Shield uses many pins, but I can't find which pins are used by the EasyVR shield.
Is the EasyVR using the RX and TX pins ? The same you use for the sketch upload ?

Which Arduino board are you using ?
Logged

Pages: [1]   Go Up
Jump to: